Lift fit guide

Measure your garage, see which lift types usually work, then check a specific model against its listed dimensions.

1. Your garage

Enter what you've measured. Ceiling height is required; the rest sharpens the result. These are general rules of thumb by lift type, set by our team, not guarantees for any model.

2. Check a specific model

Pick a lift to compare your garage with that model's listed dimensions, power and concrete requirements. Where we don't have the manufacturer data yet, we'll check it for you.

How to measure

  1. Ceiling height. Measure from the floor to the lowest point above the bay: beams, lights, the door opener or the open door and its track.
  2. Bay width and length. Measure wall to wall, and leave room to walk around the lift and open car doors.
  3. Garage door. Note the door height and where the track runs when the door is open. An open door can block a raised vehicle.
  4. Concrete. Most anchored lifts list a minimum thickness and strength (PSI). If you don't know yours, a small test hole or the building plans will tell you.
  5. Power. Check which circuit you have near the bay: 110V, 220V single-phase or 3-phase, and the breaker size.

Tips by lift type

Two-post lifts

Need the most ceiling height for full rise, and must be anchored into concrete that meets the manufacturer's spec. Overhead models need clearance for the crossbar; clear-floor (baseplate) models work under lower ceilings but have a plate between the posts. Asymmetric arms let you open car doors more easily.

Shop two-post lifts

Four-post lifts

Drive-on and usually freestanding, so concrete requirements are often lighter. Check runway length against your bay, and for storage add the height of both vehicles plus the lift's structure. Rolling jacks add wheel-free service.

Shop four-post lifts

Parking lifts

Built for storage. Measure the taller of your two vehicles and check the clearance under the raised one.

Shop parking lifts

Scissor lifts

Low- and mid-rise scissor lifts suit lower ceilings and tire, brake and body work. Full-rise and alignment scissor lifts need more height and often anchoring.

Shop scissor lifts

Portable & mid-rise lifts

Work in most standard-height garages and roll out of the way when you're done. Check the lifting height you need for the work you plan.

Shop portable & mid-rise lifts

Heavy-duty & mobile column lifts

Rated 14,000 lb and up. Plan for the vehicle's height when raised, floor load and power. Mobile columns need a flat, level floor and room to position each column.

Shop heavy-duty truck lifts

Talk to a specialist

Send us your measurements and we'll check them against the manufacturer's installation data.

Call +1 (847) 948-2563 during support hours, email support@autoliftwarehouse.com, or .

This guide is general guidance, not an installation approval. Always confirm with the manufacturer's installation manual before ordering or installing a lift.

Need help? Let's talk

Questions about fit, freight or installation? Talk to someone who knows lifts.

Call+1 (847) 948-2563During support hours Emailsupport@autoliftwarehouse.comWe reply during support hours
Support hoursMon–Fri 9:00 AM–6:00 PMSat 9:00 AM–4:00 PM · Sun closed (CT)Support hours

Buying for a shop, fleet or resale? Request a quote